Regular Maintenance - Numatic NX 1K Original Instructions Manual

!
ALWAYS ENSURE THAT THE MACHINE IS SWITCHED OFF PRIOR TO ANY
REMOVE THE KEY PRIOR TO ANY MAINTENANCE OPERATION.
1
3
IMPORTANT
If the debris basket is allowed to become clogged, vacuum
performance can deteriorate.
Located under the left hand side is a clean water filter, make
sure the clean water tank is empty before removing this filter.
Note: To make access easier, raise the brush deck.
MAINTENANCE USING THE MASTER CONTROL ON/OFF KEY.
After use, empty waste water tank
A
using emptying hose and flush out
with clean water.
A
Next remove floor tool vacuum hose
B
and flush out with clean water.
Next empty clean water tank, using
C
emptying hose and again flush out
with clean water.
Whilst pulling the top tank separator
toggles up and inwards, remove the
separator. (Fig 1)
The separator has a sealing rubber which
should be examined at every clean-down.
Rinse the separator using clean water,
remove the vac filter, clean and inspect for
any damage. (Fig 2)
IMPORTANT
Never use the machine without the
recommended filter as it may cause
damage to the machine.
Remove debris basket filter and rinse using
clean water, and refit. (Fig.3)

Regular Maintenance

B
C
11
2
!