System Menu - XIEGU G90 Operation Manual

The output power of the G90/S should be set to be ≤2.5W to protect the
amplifier. The amplifier can give full output power with very li�le drive on the
input socket.
The 8-pin ACC wire is included with the CE-19 kit. The 6-pin ACC wire is
included with the XPA125B. A coax patch lead is required to go from the
G90/Ss output port to the amplifiers input port (user supplied).
The system menu enables a good amount of customiza�on. Many of these
are a ma�er of personal preference.
Opera�on method: Hold the [FUNC] bu�on 1-2 sec. to enter the system menu.
The defini�ons of menu func�ons are as follows:
S/N Menu item
1 Handle up/down
2 Handle F1
3 Handle F2
4 LCDBL
5 AUX IN Volum
6 AUX OUT Volum
7 RCLK Tune
8 Band Stack Mode
ON/OFF Beep
9
Version
10
Descrip�on of the labels displayed at the bo�om of the screen:
PREV: previous page.
SAVE: a�er adjus�ng the system menu se�ngs, press this key to save and exit.
EXIT: exit the system menu interface directly without saving changes.
NEXT: next parameter to be adjusted.
VISIT RADIODDITY.COM FOR DOWNLOADS AND HELP

System Menu

Func�on descrip�on
Hand microphone up/down key func�on se�ng
Hand microphone F1 key func�on se�ng
Hand microphone F2 key func�on se�ng
Screen backlight brightness se�ng
ACC port input audio volume se�ng
ACC port output audio volume se�ng
Reference clock adjustment
Band stack setup
ON/OFF of system beep
Firmware version No.
39