Transmi�Er Power Se�Ng - XIEGU G90 Operation Manual

Selec�ng the stored memory channels:
1. In VFO mode, press the [VM] bu�on momentarily to enter channel mode.
2. Rotate the main tuning knob to switch to the required channel.
Clear channel memory:
1. In channel mode, press the [FUNC] bu�on followed by the [MW/MC]
bu�on. The channel number indicator will start to flash in red.
2. Rotate the main tuning knob to the channel to be wiped. Press the
[MW/MC] bu�on again to clear the selected channel.
Transmi�er Power Se�ng
1. Press the [POW] bu�on momentarily to enter the power se�ng mode. The
display area on the right side of the screen will display the current "Po"
power output se�ng value in wa�s.
2. Rotate the main tuning knob to set the power to the desired value in
steps from 1W to 20W.
It is always good to start with reduced TX power if you are unsure of your
antenna's condi�on or are new to the opera�on of your G90/S. Once you
know your SWR is low and grounding is good, the radio is designed to
operate at full power comfortably.
VISIT RADIODDITY.COM FOR DOWNLOADS AND HELP
POW key
32