Func Button; System Menu - XIEGU G90 Cheat Sheet

XIEGU G90 CHEAT SHEET

FUNC Button

Initiate a Second
Function for other
Buttons or

System Menu

Factory Reset G90
'MW .MC' Button Store VFO's Frequency
To Memory
Clear a Memory
location

A short press turns on the amber LED below the button and initiates the second function by
some other button or control. These are detailed below.
Controls.

A long press of this button will bring up the 'System Menu' to allow configuring various aspects
of the G90's operation. In each case use the 'VM' button to step through the ten options. When
making a change to one of the ten, press the 'CMP' button to save the settings and exit.. Here is
a brief overview of the options:
1. Hand Mic Up / Down button
down button's. Rotate the tuning control to select from: Freq CH +/-, Band +/-, or Volume +/-.
2. Hand Mic F1
tuning control to select from PRE/ATT, SPLT (Split operation), NB (noise blanker), COMP
(speech compressor), or AGC
3. Hand Mic F2
tuning control to select from the same choices as shown above for the 'F1' button.
4. LCD BL
to 100%.
5. AUX IN Volume
from 0 to 15 (bigger is louder)
6. AUX OUT Volume
from 0 to 15 (bigger is louder)
7. RCLK (reference clock)
positive value.
8. Band Stacking
9. G90 on / off beeping
10. Version
Note that the top mounted Band Up and Band Down buttons may also be used to step through
these 10 choices.
To complete a factory reset of the G90 press and hold the "FUNC" key and power on the G90. Then press
the "PRE" key to confirm the reset or press the "VM" key to cancel the reset.

There are memories from 00 to 63

Press 'MW.MC'

Adjust the Tuning control to select the desired memory channel.

Press 'MW.MC' button again to save the value.

You must use memory 00 first .. there after use any of the memories

Press 'FUNC' then 'MW.MC' to clear a memory

Note that the memory's are not directly tunable.
.. this allows setting the function of the hand held mic's up /
.. this allows assigning a function to the hand held mic's 'F1' button. Rotate the
.. this allows assigning a function to the hand held mic's 'F2' button. Rotate the
.. rotate the tuning control to specify the desired brightness of the display from 10%
.. use the tuning control to specify the desired ACC port's Aux In volume
use the tuning control to specify the desired ACC port's Aux Out volume
Tune. Rotate the Tuning Control to select the desired negative or
Mode. Select 'Ham Band' or 'Full Band'.
sound. Select 'Enable' or 'Disable'.
.. displays the G90's current versions of the 'APP' and 'BASE software
3