Factory Reset; Computer Control Instruc�Ons - XIEGU G90 Operation Manual

If the radio's opera�on becomes abnormal in some way, you can restore the
radio to the original factory se�ngs.
Opera�onal steps:
1.
Hold the FUNC bu�on in and power up the radio to start the restora�on of
factory se�ngs.
2. Press the [PRE] bu�on to confirm the reset. Press the [VM] bu�on to cancel
the opera�on.
Default parameters can meet most opera�ng needs. This is a good test to
see if your radio is opera�ng normally.
Computer Control Instruc�ons
The G90/S uses a subset of the standard CiV CAT instruc�on set. You can
remotely control the transceiver based on standard instruc�ons or configure
control instruc�ons for other so�ware.
Table 1 (part 1/3)
CMD Sub-CMD
0x00 -
0x01 -
0x02 -
0x03 -
0x04 -
0x05 -
0x06 -
-
0x00
0x07
0x01
0xb0
0x0F
0x00
0x01
VISIT RADIODDITY.COM FOR DOWNLOADS AND HELP

Factory Reset

DATA
see table2-1
see table2-2
see table2-3
see table2-1
see table2-2
see table2-1
see table2-2
-
-
-
-
-
-
Descrip�on
Set acvive VFO frequency
Set acvive VFO mode
Get frequency edge
Get ac�ve VFO frequency
Get ac�ve VFO mode
Set ac�ve VFO frequency
Set ac�ve VFO mode
Select the VFO mode
Select VFO-A
Select VFO-B
Swap VFO-A/B
SPLT OFF
SPLT ON
42