Mul�-Func�On Adjustment Knob; Using The Spl And Vfoa/B Func�On - XIEGU G90 Operation Manual

Mul�-Func�on Adjustment Knob (From F/W Version 1.75 onwards)
The mul�-func�on knob has several func�ons than can be customized.
By default turning the knob will tune the radio in 100kHz frequency steps.
(this is the most common use)
However, a momentary press of the knob allows adjustment of the receiving
filter.
Giving the Mul�-Func�on knob a longer press, enters the user defined
func�ons menu.
Once in the user defined func�ons menu turn either the mul�-func�on knob
or the main tuning dial to go to one of the following func�ons:
1
2
3
4
5
When you are on the func�on you want to adjust e.g. squelch, momentarily
press the mul�-func�on knob in again. This will take you back to the normal
opera�ng screen. As soon as the receive screen is displayed rotate the
mul�-func�on knob and where the bandwidth icon is normally displayed on
the screen, the available values for the selected func�on available will be
displayed as you turn the knob. When you have the value displayed that you
wish to have, momentarily press the mul�-func�on knob again to keep the
value.
NOTE: If you wait too long you will be put into DSP filter adjustment mode. If
this happens, start again.
Recep�on and Transmission Opera�ons Using the SPL and VFOA/B.
The G90/S transceiver has two built-in, independent, VFOs which can be set to
different frequencies and different modes. Using the SPL (split) func�on, you
can transmit and receive on different frequencies.
VISIT RADIODDITY.COM FOR DOWNLOADS AND HELP
Freq 100k
SQL Level
Po Level
Key Speed
FFT Scale
Frequency stepping value
Mu�ng level se�ng
Transmi�er output power
Automa�c key rate selec�on
Spectrum reference level se�ng
21