Install The Fan Guard; Install The Kleanshield - Cleveland SteamChef 22CGT3.1 Operation Installation Maintenance Manual

I. Install the Fan Guard and Air Diverter
Note: See Figure 3-8.
a. To Install the fan guard and air diverter:
a. Hold the fan guard so that the large ends of the keyholes are towards the bottom of the SteamChef.
b. Place all four openings over the mounts located on the rear wall of the SteamChef.
c. Pull it down so that the narrow ends of the slots are pulled tight over the mounts. See Figure 3-8.
d. Place the air diverter over the fan guard. Press lightly towards the rear wall until the air diverter
drops into its slots in the fan guard.
J. Install the KleanShield™
Note: See Figure 3-8.
Never operate a SteamChef without a properly installed KleanShield.
1. Place the KleanShield into the SteamChef so the drain trough slips into the KleanShield™ drain at
the rear of the cooking compartment.
2. Carefully lower the front of the KleanShield™ so the Water Level Sensor Guard is behind the probes
and the front legs rest on the bottom of the cooking compartment.
The fan guard helps protect the operator from injury caused by the rotating fan blades.
Never operate a SteamChef without the fan guard properly installed.
Operating a SteamChef without the fan guard properly installed can cause injury,
equipment damage, and reduce performance.
Figure 3-7
Typical Drain Layout
24