Cleaning Procedure - Cleveland SteamChef 22CGT3.1 Operation Installation Maintenance Manual

Cleaning Procedure (Continued)
Daily cleaning will help prevent the buildup of calcium and other mineral deposits ("scale") left by boiling
water and help prevent more costly maintenance and service on the SteamChef.
NOTICE: Do NOT use abrasive cleaning compounds or steel wool.
1. Turn the ON/OFF lever OFF (counter-clockwise) See Figure 3-3. The SteamChef will begin a 3-minute
drain rinse cycle to clean the drain system.
2. Open the SteamChef door and allow SteamChef to cool.
3. Remove any spilled food from the surface of the KleanShield.
4. Remove the slide racks, air diverter, fan guard, and KleanShield. Wash and rinse slide racks, air
diverter, fan guard, and KleanShield separately or clean them in a dishwasher according to health
requirements.
5. Remove any spilled food from inside compartment and clear any residue from the drain valve and the
KleanShield drain opening.
6. Clean the interior of the compartment thoroughly, removing all food particles and scale.
7. Do NOT push food scraps, debris, or scale down the reservoir drain, or down the KleanShield drain.
8. Wipe the interior of the cooking compartment with half water and half white household vinegar solution.
9. Use a spray bottle of the same vinegar solution to rinse the convection fan blade located at the back of
the cooking compartment.
10. Use a soft bristle brush to clean the water probes and fan, and to remove stubborn food particles.
11. Cleveland Range does not recommend the use of detergent, but if detergent has been used to clean the
inside of the SteamChef, be sure to rinse off the probe assembly with the vinegar solution.
detergent residue is not completely rinsed from the probe assembly then the residue can prevent the
water level control from operating.
12. Rinse the inside of SteamChef compartment and drain valve thoroughly with clean water.
13. Clean the door assembly.
a. Remove the door gasket assembly. See Figure 4-1.
b. Note the keyhole slots on the door and the retaining pins on the gasket
assembly. Grasp the gasket assembly at the sides and lift up and
towards you to remove the assembly.
c. Clean all surfaces of the gasket assembly, as well as the inside of the
door, by wiping with a damp cloth.
d. Rotate the liner assembly 180 and replace the gasket assembly by
sliding the retaining pins into the keyhole slots. Either long edge of the
gasket assembly can be positioned at the top. Periodic rotating of the
door assembly will help increase the door gasket life.
14. Replace the cleaned KleanShield, fan guard, and slide racks.
15. Wipe the exterior with a damp cloth only.
16. NEVER HOSE DOWN THE STEAMCHEF. Electrical and electronic components of the SteamChef will
not function correctly if wet or damp and may cause a shock hazard.
17. After cleaning, leave the SteamChef door open until the next use. This prevents compartment odor
buildup and increases gasket life.
Figure 4-1 Door Gasket Assembly
If
14