Vermeiren Inovys II User Manual page 20

EN
NL
3.4.1 Backrest and seat inclination
CAUTION
• Be aware that the stability decreases when the wheelchair is moved from sitting upright to
inclined position.
• Apply the parking brakes before adjusting the backrest and seat inclination.
The seat inclination and backrest inclination can be adjusted simultaneously or separately by an
attendant. Make sure that the patient sits in the chair when the attendant adjusts the backrest
inclination and that the wheelchair does not tip over.
Seat inclination:
1. Squeeze the lever (1) on the left handle (see label) towards the handle to adjust
the seat inclination.
2. Pull/Push the seat in the desired position (0° to + 21°), the gas pressure spring
shall be pressed in/out.
3. Loosen the lever (1) to block the gas pressure spring.
Backrest inclination:
1. Squeeze the lever (1) on the right handle (see label) towards the handle to adjust
2. Pull/Push the backrest in the desired position (0° to + 54°), the gas pressure
3. Loosen the lever (1) to block the gas pressure spring.
3.4.2 Armrest height
The arm pads (3) of the wheelchair can be adjusted in 6 different
height positions:
1. Turn the star knob (45) anticlockwise to unlock.
2. Pull and hold the star knob to release the inner tube of the
armrest (9).
3. Slide the inner tube of the armrest (9) up/down in the support
(46) until the desired height. Make sure that the holes on the
inner/outer tube align.
4. Retighten the star knob (45) by turning it clockwise.
5. Repeat this for the second armrest. Make sure that the
armrests is firmly secured.
Risk of injuries or damage
the angle of the backrest.
spring shall be pressed in/out.
If your wheelchair features drum brakes, the levers (1) are
used as brakes; additional levers (3) have been mounted
to adjust the backrest and seat inclination.
Figure 8 Adjusting armrest height
16
Inovys II, Inovys II kids
2021-11
Using your wheelchair
3
9
45
46