Timer Setting; Alarms; Overtemperature Alarm - ZANOLLI CITIZEN Series Installation, Use And Maintenance Manual

_________________________________________________________________5. WORKING
Pressing again memorises the time and day of the week on which the
oven will automatically switch on. Once set and memorised, the
returns to displaying the current time and the dot between the
hours and minutes flashes. The dot following the minute display remains lit
indicating that a time has been set for automatic switch-on.
To permit automatic switch-on the oven must be on standby (system
general switch
display.
To be sure that the system has correctly memorised the setting, check that
the dot to the lower right of the

5.4.4 Timer setting

While the oven is operating, that is to say when the elements have been
enabled by pressing the
means of the
hours and minutes that decreases with the flashing dot between the two
figures. The value that appears on the display can be modified using the
and keys and begins counting 2 seconds after setting.
At the end of the set time an alarm sounds for 10 seconds and the
display shows 4 zeros that flash until the oven is switched off
by means of the
twice.
While the timer is active either the remaining time or the actual temperature
of the oven can be displayed on the
5.5

Alarms

5.5.1 Overtemperature alarm

If due to malfunction the internal temperature of the oven exceeds 400°C
the system will immediately stop the current cycle.
The remote general switch is disabled along with all oven functions.
The message "OFF" disappears from the
the message "ALLO".
To reset the alarm and reset the system, press
If the oven is reactivated before temperature has fallen below 400°C the
alarm will trigger again.
In any case have the oven checked by a qualified maintenance technician
to rectify the cause of the problem before using the oven again.
____________________________________________________________________________
22 CITIZEN 6 - 9/MC, CITIZEN 6+6 - 9+9/MC DIGITAL VERSION
ON and temperature setting displayed on
button, the timer can be started at any time by
button. The
button, or the timer function is refreshed by pressing
display is on.
display shows the timer value in
display by pressing
display and is replaced by
.
.