Specifications - Eastwood B100 Instructions Manual

Abrasive media blast cabinet

Table of Contents

The EASTWOOD ABRASIVE MEDIA BLAST CABINET – B100 is constructed of heavy gauge steel with a quality powdercoated finish for maximum durability

and trouble-free service. It features a high-intensity dual-tube fluorescent work lamp for increased visibility and a baffled, flow-through ventilation design with an

included integral, high capacity vacuum unit, all in a compact, space saving configuration. The unique clam shell front opening design provides much greater ease

and safety with a low lift-over height when blasting larger or heavier items.

INCLUDES

COMPONENTS

(1) Blast Cabinet Assembly – A

(4) Legs – B

(2) Leg Side Braces – C

(1) Light Fixture (installed under lid for shipping) – D

(2) Fluorescent Tubes – E

(1) Glass Lamp Protection Panel

(1) Pick-up Tube/Gun/Hose Assembly – G

(1) Perforated Floor Panel – H

(1) Regulator/Air Valve/Foot Pedal Assembly – J

(1) Vacuum/Filter Assembly – K

(5) Peel-Off Window Shields

(5) Peel-Off Lamp Protection Panel Shields

(3) Spare Nozzles

(1) Roll Teflon Tape

HARDWARE

(35) M6 x 12mm Pan Head Screws

(35) M6 Self-Locking Nuts

REQUIRED FOR USE

• The inlet air supply must have a moisture separator capable of removing all moisture and impurities from the air supply. Moisture and/or oil in the

air supply will cause clumping and clogging of the abrasive media.

• The included regulator must be used to limit incoming air pressure to 90 PSI maximum. Excessive air pressure can cause permanent damage to the unit

and possible serious personal injury from bursting.

• For best results, a compressor capable of providing a minimum of 12 CFM @ 90 PSI is required. Less available CFM will not provide sufficient force to

allow the Blaster to adequately remove rust and or paint.

• The use of Eastwood blast media is strongly recommended for proper operation. Use care to avoid using excessive grit size which can block the Nozzle.