Eastwood B100 Instructions Manual page 6

ADD LEG SIDE BRACES TO LEGS (C TO B)
• Place a Leg Side Brace behind a set of Legs and align the
screw holes (FIG 6).
• Add 2 M6 x 12mm Screw and Nuts and tighten securely
(FIG 6).
• Close the Clamshell Lid against Gas Cylinder pressure and
latch Clasps securely.
The following step requires the assistance of
a capable helper as the unit is very heavy!
When raising, the rear Legs are not fully at-
tached to the Cabinet and may be damaged
or bent if not properly supported. The use of
safety shoes is strongly advised.
• With helper, place gloved hands along rubber seal inside
the open light fixture slot at the top of the Cabinet and lift
slowly and steadily to upright position. DO NOT allow legs
to collapse.
• Align all holes in Legs and Cabinet and add an additional
4 sets of Screws and Nuts per side. Tighten all hardware
securely (FIGS 7 & 8).
6
FIG. 6
FIG. 7
FIG. 8
Eastwood Technical Assistance: 800.343.9353 >> tech@eastwood.com