Eastwood B100 Instructions Manual page 4

ASSEMBLY
The Eastwood Abrasive Media Blast Cabinet
consists of large, heavy metal components
which can cause potentially serious injuries if
allowed to drop. Avoid pinching hands while
handling parts during assembly. The assis-
tance of a helper during assembly is neces-
sary. The use of safety shoes is advised.
PREPARING BLAST CABINET FOR ASSEMBLY
• With a capable helper, carefully set the Blast Cabinet on its
back, on a secure working surface, with the round glove
holes facing upward (FIG 1).
REMOVE LIGHT FIXTURE AND GLASS PANEL FROM SHIPPING
POSITION
(D & F FROM A)
• Carefully unlatch the clasps holding the Clamshell Lid
closed and allow it to slowly open with pressure from the
attached Gas Cylinders (FIG 2).
• Reach in and while supporting the Light Fixture (D), loosen
the six M6 screws holding it in place at the underside of the
roof of the Cabinet.
• Carefully withdraw the Light Fixture (D) and the Glass
Lamp Protection Panel (F).
Wear appropriate work gloves to avoid
receiving cuts from sharp edges of the
Glass panel (F).
• Set the Light Fixture (D) and the Glass Lamp Protection
Panel (F) aside in a secure location along with the six
removed screws for top of Cabinet installation later.
4
FIG. 1
FIG. 2
Eastwood Technical Assistance: 800.343.9353 >> tech@eastwood.com