Eastwood B100 Instructions Manual page 12

INSTALL VACUUM/FILTER ASSEMBLY TO CABINET (K TO A)
NOTE: The Vacuum/Filter Assembly is moderately heavy, and it is
best to remove the Motor and Filter before installing on the Cabi-
net. Also, the assistance of a capable helper is necessary.
• Place the Vacuum/Filter Assembly on the floor and unlatch
the 2 Clasps.
• Pull the Motor & Filter out of the top of the Housing and set
it aside.
• With the assistance of a helper, align the mounting holes of
the brackets with the 4 holes at the upper back wall of the
Cabinet. Secure it in place using 4 sets of M6 Screws and
Nuts (FIG 20).
• Carefully lower the Motor/Filter Assembly back into the
mounted Housing and latch the Clasps securely (FIG 21).
• Connect the Plug on the power supply cord with the
female Receptacle on the cord attached to the Light
Fixture (FIG 22).
• The Eastwood Abrasive Media Blast Cabinet is now fully
assembled and ready for set-up.
12
FIG. 20
FIG. 21
FIG. 22
Eastwood Technical Assistance: 800.343.9353 >> tech@eastwood.com