Eastwood B100 Instructions Manual page 5

ATTACH LEGS TO BLAST CABINET (B TO A)
• Slide a Leg (B) under the rear, lower corner of the cabinet
(A) as a rear leg with 4 screw holes aligned (FIG 3).
NOTE: 2 of the screw holes are inaccessible at this point.
• Pass 2 M6 x 12mm Screws through holes from the outside,
add M6 Nuts (FIG 4). Tighten securely.
• Place another Leg (B) over the front corner of the Cabinet
(A) aligning 4 sets of holes.
NOTE: It is advisable to have a helper support the Leg while
aligning holes, and installing hardware.
• Insert 4 M6 x 12 mm Screws from the outside and add
4 Nuts (FIG 5).
• Repeat for front and rear legs at opposite side.
To order parts and supplies: 800.343.9353 >> eastwood.com
FIG. 3
B
FIG. 4
B
FIG. 5
A
Holes
A
5