Table of Contents
Advertisement
The HOTCOAT POWDER COATING OVEN is a full-sized commercial unit designed for professional powder coating shops but is an excellent addition for any well-
equipped home-based business. A highly efficient, 3 heating element system requires readily available 220 Volt AC power at only 39 Amps and requires no outside
venting for use anywhere convenience. Generous interior dimensions with quick temperature ramp-up and recovery allow for rapid production turnaround times.
SPECIFICATIONS
Heating Element Power Requirements: 240 Volt AC, 60Hz, 39-Amp, 8,500 Watt, Single Phase
Fan Power Requirement:
Interior Dimensions:
Exterior Dimensions:
SAFETY INFORMATION
The following explanations are displayed in this manual, on the labeling, and on all other information provided with this product:
DANGER indicates a hazardous situation which, if not avoided, will result in death or serious injury.
WARNING indicates a hazardous situation which, if not avoided, could result in death or serious injury.
CAUTION indicates a hazardous situation which, if not avoided, could result in minor or moderate injury.
NOTICE is used to address practices not related to personal injury.
READ INSTRUCTIONS
• Thoroughly read and understand these product instructions before using the Oven.
• Keep these product instructions for future reference.
• Never apply powder coating in or in front of an operating oven. Always operate the oven in a well–ventilated area.
• Never allow the Oven to operate unattended. Always disconnect Oven from the electrical power supply before leaving it unattended.
• Never use the HotCoat Oven outdoors when it is raining or in wet or damp areas, as it may cause an electric shock.
• Connect only to a 240VAC, 60Hz, 40 Amp circuit meeting all applicable local electrical codes.
• DO NOT allow children, persons or animals access to the oven. The door is latched from the Outside Only and cannot be unlatched from
the inside!
2
120 Volt AC, 60Hz, 6Amp
68.5" [1.73m] high x 40.5" [1.02m] wide x 44.5" [1.13m] deep (71 cubic feet) [2 cubic meters]
72-1/2" [1.84m] high x 48-1/8" [1.2m] wide x 48-1/4" [1.2m] deep (Cabinet only, no external appendages)
FIRE OR EXPLOSION HAZARD!
FIRE HAZARD
ELECTRICAL SHOCK HAZARD!
ENTRAPMENT HAZARD!
Eastwood Technical Assistance: 800.343.9353 >> tech@eastwood.com
Advertisement
Table of Contents
