Page 2
BENCH MOUNTING • Place the Eastwood Versa-Bend on a clean, stable, level surface at a comfortable working height. Mount securely to the work surface using 4 suitable 5/16" [8mm] lag screws or bolts (not included) through the four 21/64" [8.3mm] diameter holes in the base (Fig 3).
Page 3
fi nal bends. • For successive bends, loosen the Clamping Beam, fl ip the panel over, place in under the Clamping Beam then repeat steps outlined above. (Fig 7a, 7b, 7c). Fig. 7c To order parts and supplies: 800.345.1178 >> eastwood.com...
Page 4
#20258 Protractor #20259 Ruler If you have any questions about the use of this product, please contact The Eastwood Technical Assistance Service Department: 800.544.5118 >> email: techelp@eastwood.com PDF version of this manual is available online >> eastwood.com/14042manual The Eastwood Company 263 Shoemaker Road, Pottstown, PA 19464, USA US and Canada: 800.345.1178...