Eastwood B100 Instructions Manual page 8

INSTALL LIGHT FIXTURE AND GLASS PANEL TO TOP OF
CABINET LOCATION (D & F TO A)
Wear appropriate work gloves to avoid
receiving cuts from sharp edges of the
lass panel (F).
• Set and center the Glass Lamp Protection Panel (F) over
the rubber seal WITH PEEL-OFF PROTECTIVE COVER facing
downward toward inside of Cabinet (FIG 11).
• Place the Light Fixture (D) with Switch facing forward over
the Glass Panel (F) and align the 3 mounting slots per side
with the 6 holes in the cabinet top (FIG 12).
• Add the 6 previously removed Light Fixture Screws.
NOTE: No nuts are required as these are pre-attached
weld-nuts (FIG 13).
8
FIG. 11
FIG. 12
FIG. 13
Eastwood Technical Assistance: 800.343.9353 >> tech@eastwood.com