Maintenance - Eastwood B100 Instructions Manual

MAINTENANCE

REPLACE PEEL-OFF WINDOW SHIELD
• The interior side of tempered glass Lid Window is equipped with a replaceable, full-view, peel-off, self-adhesive flexible window shield.
It will become cloudy with use.
To replace:
- Peel off worn protector.
- Gently clean glass with a soft cloth and glass cleaner or alcohol.
- Peel off adhesive protective strips and apply replacement shield to interior glass surface. Press on adhesive areas to ensure an abrasive proof seal.
REPLACE PEEL-OFF LAMP PROTECTION PANEL SHIELD
• The interior side of tempered glass Lamp Protection Panel is equipped with a replaceable, peel-off, self-adhesive flexible window shield.
It will gradually become cloudy with use and can diminish light intensity.
To replace:
- Peel off worn protector.
- Gently clean glass with a soft cloth and glass cleaner or alcohol.
- Peel off adhesive protective strips and apply replacement shield to interior glass surface. Press on adhesive areas to ensure an abrasive proof seal.
CERAMIC NOZZLE REPLACEMENT
• Replace the Nozzle when you notice excessive air and blast
media being used or cleaning efficiency is reduced. Nozzle
replacement on the Blast Gun is easy. After disconnecting
the unit from the air supply, unthread the Nozzle Fer-
rule from the front of the Gun Body, remove the Ceramic
Nozzle, install replacement and thread the Nozzle Ferrule
back in place (FIG 25).
• The Blast gun is now once again ready for use.
JET REPLACEMENT
• Replace the Jet when you notice excessive air and blast
media being used or cleaning efficiency is reduced.
To replace:
- Disconnect Blast Cabinet from air supply.
- Remove Air Inlet Fitting from the rear of the
Jet Assembly.
- Loosen Air Jet Lock Nut and turn Air Jet out of rear of Gun.
- Install new Air Jet, then tighten Air Jet Lock Nut.
- Reinstall Air Inlet Fittings.
- The Blast gun is now once again ready for use.
14
FIG. 25
Ferrule Nozzle
Eastwood Technical Assistance: 800.343.9353 >> tech@eastwood.com
Lock Nut
Jet Air
Inlet
Fitting