Bosch GTC 600 C Professional Original Instructions Manual page 13

Always keep the flap of the USB port closed so that dust and
splashes cannot enter the housing.
Note: Use USB to connect the measuring tool to a computer
only. The measuring tool may be damaged if connected to
other devices.
Note: The USB Type-C® interface can only be used for data
transfer. It is not suitable for charging non-rechargeable and
rechargeable batteries.
Post-Editing the Thermal Images
You can post-edit the saved thermal images on your com-
puter if it uses a Windows operating system. To do so, down-
load the GTC Transfer software from the product page for
the measuring tool at www.bosch-professional.com.
Data transmission via Wi-Fi
The measuring tool is equipped with a Wi-Fi interface which
enables the saved images taken by your measuring tool to be
wirelessly transmitted to a mobile device.
Special Bosch applications (apps) are available for this use.
They can be downloaded in the store corresponding to your
device:
Errors – Causes and Corrective Measures
In the event of a fault, the measuring tool will restart and can then continue to be used. If the fault persists, the following over-
view may help you.
Error Cause
Measuring tool cannot be Battery pack empty
switched on.
Battery pack too hot or too
cold
Measuring tool too hot or too
cold
Image memory full
Image memory defective
Slow data transfer via Wi-Fi
connection
Measuring tool not recognised
by computer.
Measuring tool cannot be con-
USB port or USB cable defect-
nected to a computer.
ive
Button cell empty
Measuring tool faulty
Bosch Power Tools
In addition to the wireless data transfer of your images, the
Bosch applications make it possible for you to use an exten-
ded range of functions and make it easier to post-edit and
forward measured data (e.g. via e-mail). Information about
system requirements for a Wi-Fi connection can be found on
the Bosch website at www.bosch‑professional.com.
To activate or deactivate the Wi-Fi connection on the meas-
uring tool, call up the main menu, use the buttons to
select <WiFi> and activate or deactivate it. The indicator (e)
appears in the display when the Wi-Fi is activated. Ensure
that the Wi-Fi interface is activated on your mobile device.
The connection between the mobile device and the measur-
ing tool can be established after the Bosch application has
been started (if Wi-Fi modules are activated). To do this, fol-
low the instructions in the application (app).
Corrective measures
Charge the battery.
Allow the battery pack to reach the correct temperature or
change it.
Allow the measuring tool to reach the correct temperature.
Transfer the images to another storage medium (e.g. com-
puter) when necessary. Then delete the images in the internal
memory.
Format the internal memory by deleting all images. If the
problem persists, send the measuring tool to an authorised
Bosch after-sales service centre.
Change the Wi-Fi channel (in the main menu via <Tool> →
<WiFi Channel>).
Check whether the driver on your computer is up to date. It
may be necessary to have a newer operating system version
on your computer.
Check whether the measuring tool can be connected to a dif-
ferent computer. If not, send the measuring tool to an author-
ised Bosch after-sales service centre.
Change the button cell(see "Changing the Button Cell
(see figure B)", page 14) and confirm the change.
Send the measuring tool to an authorised Bosch after-sales
service centre.
English | 13
1 609 92A 58Z | (22.02.2021)