Advertisement
8.
Position Plywood so it sits almost flush with outside of floor joist framing (see Note). When correctly
positioned, attach to all floor joists with approximately 24 - 1 1/4" Screws. Use screws every 16".
B. Wall Section
Wall Extenders (2)
Extender Top
Siding piece (2)
Angled Wall
Extenders (2)
Door Header - Long
3/4" thick Filler Trim
Interior Door
Header
Door Jamb
Solid Front Wall
Panel - 73" high
Wall Plate (5)
9.
Locate 5 Solid Wall Panels and 5 Wall Plates (1 1/2" x 2 1/2" x 45 1/2"). Attach Plates to
bottom of studs of each wall panel with 3 - 2 1/2" Screws. Position so plates are flush with framing.
Toll Free 1-888-658-1658
Note: Plywood is cut slightly smaller than
floor framing. Keep plywood seams tight.
Exploded view of all parts necessary to
complete the Wall Section. Identify all parts
prior to starting.
Important:
Pilot hole ALL 2x3 Wall
Studs with 1/8" drill bit prior to
screwing. This will make it much
easier to attached together.
Wall Plate
www.outdoorlivingtoday.com
Page 9
Horizontal
Wall Cleats
Door Header
- Short
Solid Wall
Panel (4)
7/8" thick Filler Trim
sales@outdoorlivingtoday.com
Pilot Hole
first.
Advertisement
