Inspecting The Machine - McConnel ROBO-CHIPPER ROBOCUT Operations & Parts Manual

ROBOCUT ROBO-CHIPPER
2.1.4 –

Inspecting the machine

• Inspect the machine thoroughly every day before using it, following the checklist indicated in
this manual.
• Start the engine only in a well ventilated area and ensure that there are no persons in the
machine's working range.
• Covers and safety devices must not be removed. They are designed and manufactured for
your safety.
• Do not use the machine if the safety devices or covers are damaged or missing.
• Make sure all safety devices are put back in place immediately after cleaning or repair work
has been carried out.
• Keep the machine and all its accessories clean and in good working order at all times. Remove
any cuttings that have been deposited on the machine. WARNING: Fire danger!
• It is strictly prohibited to make modifications to the machine without prior authorisation from the
manufacturer. Changes to the machine can cause hazards and injuries. The manufacturer shall
not be held responsible for the machine if these instructions are not followed.
• Only refuel when the machine is switched off, if possible before having turned it on, and when
the fuel tank is cold. If you need to refuel whilst work is in progress, do not add fuel to the tank
if the tank is hot or if the engine is still warm. Allow the machine to cool down. WARNING:
Danger of explosion and fire!
• Apply a guard or cover with appropriate means before cleaning.
8