Rv50 Series Hardware And Software Specifications At A Glance - Sierra Wireless AirLink RV50 Series Hardware User's Manual

AirLink RV50 Series Hardware User Guide
RV50 Series Hardware and Software
Specifications at a Glance
Table 2-1: Hardware and Software Specifications
Network Technology
Host Interfaces
SIM Card Interface
Input / Output
For more information, see
Power Adapter Pins
Reset
LEDs
Mechanical Specifications
For mechanical drawings, see
Specifications on page 59.
Screw Torque Settings
Operating Voltage
Rev. 6 October 2021
See
•
•
•
•
Two mini-SIM (2FF) slots
Configurable I/O pin on power connector
•
page 32.
•
•
•
4-Pin connector:
•
•
•
•
Manual reset button or using ACEmanager
4 LEDs:
•
•
•
•
•
Mechanical
•
•
•
•
•
Input voltage: 7–36V
Maximum ripple voltage to guarantee analog input accuracy: 100
mVpp
Radio Frequency Bands on page 47.
10/100/1000 Base-T RJ-45 Ethernet
RS-232 serial port
USB 2.0 Micro-AB connector
3 SMA antenna connectors (LTE, Diversity, Active GNSS)
Digital Input
High side configurable internal pull-up (to Vin) resistor
Analog input
Open collector output/low side sink
Power
Ground
Configurable digital I/O and analog voltage input sensing
Configurable ignition sense
Network
Signal
Activity
Power
119 mm × 34 mm × 85 mm (94 mm including connectors)
4.69 in. × 1.34 in. × 3.35 (3.70 in. including connectors)
320 g (11.3 oz.)
Housing—The RV50 Series gateway is made of ruggedized
powder-coated aluminum.
RoHS—The RV50 series gateway complies with the Restriction
of Hazardous Substances Directive (RoHS). This directive
restricts the use of six hazardous materials in the manufacture of
various types of electronic and electrical equipment.
DIN rail mount screws
(for attaching the RV Series to the DIN rail)
1.1 N-m (10 in-lb)
Antennas
Finger tight (5–7in-lb.) is sufficient and the max torque should
not go beyond 1.1 N-m (10 in-lb).
16 4117313