Sample Power Consumption Scenarios - Sierra Wireless AirLink RV50 Series Hardware User's Manual

AirLink RV50 Series Hardware User Guide

Sample Power Consumption Scenarios

Table 1-3: Power Consumption Scenarios
Scenario Radio
Standby Mode —
Low Power — Idle
Serial Attached
Low Power — Idle
Ethernet Attached
Typical Attached
without Power and
Saving connected
Features (+20 dBm
LTE)
RV50X Only — Attached
Maximum and
without Power connected
Saving (+23 dBm
Features LTE-A)
RV50 Only — Attached
Peak without and
Power Saving connected
b
Features (+32 dBm
1 up/
1 down
GSM/
GPRS/
EDGE
bursts)
1.5 A @ 12 V (Averaged over 100 s)
Inrush Current
a. Power consumption was measured at 12 V.
b. Peak without power saving is similar to Maximum without power saving, but measured as a maximum burst over a limited time.
Rev. 6 October 2021
Ethernet Serial
— — —
Disabled Enabled Disabled
10 BaseT Disabled Disabled
Full duplex
100 BaseT Enabled Enabled
Full duplex Idle Idle
1000 Enabled Enabled
BaseT Full
duplex
(maximum
throughput)
1000 Enabled Enabled
BaseT Full
duplex
(maximum
throughput)
12
USB GNSS Processor
Power
Saving
Mode
— —
Disabled Enabled
Disabled Enabled
Enabled Disabled
Active
antenna
Enabled Disabled
Active
antenna
Enabled Disabled
Active
antenna
LED a
Power
Power
Saving
Mode
— 53 mW
(4.4 mA)
Enabled 885 mW
(73.7 mA)
Enabled 900 mW
(75 mA)
Disabled 3700 mW
(308.3 mA)
Disabled 5500 mW
(458.3 mA)
Disabled 8000 mW
(666.6 mA)
4117313