Canon FAX-L800 User Manual page 313

5.TX TERMINAL ID
ON
OFF
6.DENSITY CONTROL
7. SCAN RESOLUTION
SUPER FINE
ULTRA FINE
8.PROGRAM KEY
PRINT REPORT
REPORT
SCANNING MODE
STAMP
Chapter 16
Print your ID (transmitting terminal ID) on each page you transmit.
(Q3-11)
After you turn the terminal ID ON, you can do the following
settings.
1.TTI POSITION
OUTSIDE IMAGE
INSIDE IMAGE
2.TELEPHONE # MARK
FAX
TEL
No terminal ID is not printed on the pages you send.
Adjust the scanning density from 1-5 for DK (2 is default), 2-6 for
STD (4 is default), 3-7 for LT (6 is default).
Set the default value for the SUPER FINE setting of the
RESOLUTION button on the operation panel. (Q6-4)
Scans at 8 dots/mm, 15.4 lines/mm.
Scans at 16 dots/mm, 15.4 lines/mm.
Use the program button to streamline the procedures for printing
activity reports or doing the scanner settings. (Q12-4)
Press the PROGRAM button whenever you need a transmission
report for a document you are sending.
If you select this setting, you do not have to open both One-touch
Speed Dialling panels to start printing a report. Whenever you need
to print a report, press the PROGRAM button.
Set the scanner buttons (Resolution, Contrast, Document Type) for
special settings, like sending a photograph for example. Then you can
adjust all the settings just by pressing the PROGRAM button.
If you have installed the optional stamp feature, this option is
available. If you select STAMP you can turn the stamp feature on or
off without opening both One-touch Speed Dialling panels to press
the STAMP button.
Terminal ID prints outside the image
border
Terminal ID prints inside the image
border.
You can prefix your number with the
abbreviations FAX or TEL in your
sender ID.
Prefixes the number with the
abbreviation FAX.
Prefixes the number with the
abbreviation TEL.
Summary of Important Settings 16-5