Canon FAX-L800 User Manual page 143

SET
3. Press SET then follow the summary in the table below to perform the
4. Press STOP to return to standby.
Transfer Setup Summary
1.FILE NAME
2.SELECT LOCATIONS
3.PASSWORD
4.SELECT ORIG UNIT
Chapter 7
settings.
The default settings, shown in bold below, remain in effect unless you change
them.
Enter a file name up to 24 characters long.
Select the numbers of the fax machines where you want documents
transferred.
TEL =
0000-9999
Enter a four-digit number (0000-9999) to protect the transfer file
settings. Use of a password is recommended. This operation
password protects the transfer file from unauthorized access to your
settings. You will also need to enter this password when you put the
fax in the document transfer mode.
Allows you to set the fax to receive and relay documents only from
originator fax units that you designate.
OFF
ON
TEL =
Close the One-touch Speed Dialling panels
and press a One-touch Speed Dialling button
or press the CODED DIAL button followed
by a three-digit code for the Coded Speed
Dialling number to enter the number of the
fax machine where you want documents
transferred. The telephone number of the
destination fax must be registered for One-
touch or Coded Speed Dialling on your fax.
All fax transmissions are received and
transferred.
The fax machine receives and transfers
transmissions only from fax units that you
designate by fax telephone number.
Press the One-touch Speed Dialling button or
press the CODED DIAL button followed by
the three-digit code to designate the
originator fax machines for receive and
transfer. The telephone number of the
originator fax must be registered for One-
touch or Coded Speed Dialling on your fax.
Receiving Documents 7-13