Table of Contents
Advertisement
2.4.4 Using and selecting the different active operating modes
In "Heating" mode, the heat pump has 3 active operating modes for adjusting its operating speed to the power that is
required and the mode that is selected.
Depending on the selected operating mode ("BOOST", "SMART" or "ECOSILENCE"), the power delivered by the heat
pump can vary over a predefined range (depending on the speed of its compressor and fan).
The number of lit LEDs on the strip reflects the compressor's actual operating speed. This feature is particularly useful
in the "SMART" and "ECOSILENCE" modes to see if the machine is operating at its maximum over the predefined power
range or, on the contrary, at a reduced power level.
HIGH
100%
MID
75%
LOW
50%
The LED strip goes up to "HIGH"
Status
Quickly increasing the setpoint
Objective
When to use
When commissioning the pool
* The compressor speed directly affects the appliance's power output.
To select the active operating mode:
• From the main screen (where the measured water temperature is displayed), press
front of one of the 3 operating modes ("BOOST", "SMART" or "ECOSILENCE").
• Press
until reaching the desired mode. Once the indicator
it is confirmed automatically.
15
BOOST
between "LOW", "MID" and
Intelligently controlling the
temperature
To avoid having to intervene on
Active operating mode
SMART
or
or
The LED strip fluctuates
"HIGH"
Heating
operating speed
Automatically adapting the power to requirements
To maintain the temperature
the appliance
is placed in front of the desired operating mode,
ECOSILENCE
or
The LED strip fluctuates
between "LOW" and "MID"
Operating the most
economically and quietly
To benefit from quiet operation
when little heating is required
. The indicator
stops in
Hide quick links:
Advertisement
Table of Contents
