Table of Contents
Advertisement
Coolant Level Adjustment
Warning
Do not remove the expansion tank or
radiator
pressure
engine is hot.
When the engine is hot, the coolant
inside the radiator will be hot and also
under pressure.
Contact with this hot, pressurised
coolant will cause scalds and skin
damage.
Caution
If hard water is used in the cooling
system,
it
will
accumulation
in
radiator and considerably reduce the
efficiency of the cooling system.
Reduced cooling system efficiency
may cause the engine to overheat and
suffer severe damage.
1
2
B01160
1. Expansion tank cover
2. Spigots
3. Grommets
4. Expansion tank cap
5. MAX mark
6. MIN mark
cap
when
the
cause
scale
the
engine
and
3
4
5
6
MAINTENANCE
To adjust the coolant level:
▼ Allow the engine to cool for a
minimum of 30 minutes.
▼ Position the motorcycle on level
ground and in an upright position.
▼ Grasp the coolant expansion tank
cover firmly in both hands and gently
pull the top edge of the panel away
from the motorcycle until the spigots
are
away
from
grommets (leaving the grommets in
place).
▼ The coolant level must be between
the MAX (upper line) and MIN (lower
line) marks in the expansion tank.
▼ Remove the coolant expansion tank
cap from the coolant expansion tank.
▼ Add coolant mixture through the
filler opening until the level reaches
the MAX mark.
▼ Refit the coolant expansion tank cap.
▼ Position
the
expansion
tank
grommets.
▼ Press firmly to secure the cover.
▼ Grasp the cover and make sure that
it is fully retained.
the
retaining
spigots
on
the
cover
to
the
123
Advertisement
Table of Contents
