Table of Contents
Advertisement
GENERAL INFORMATION
42
To select a riding mode:
▼ Press and release the MODE button
on the left hand switch housing to
activate the riding mode selection
tray.
▼ The currently active riding mode icon
is shown highlighted.
To change the selected riding mode:
▼ Press the joystick down or up, or
repeatedly press the MODE button
until the required riding mode is
highlighted in the centre of the
riding mode selection tray.
▼ A brief press of the joystick centre
will select the required riding mode,
and the riding mode icon in the right
hand side of the display will change.
▼ The selected mode is activated once
the following conditions for switching
modes have been met:
Motorcycle Stationary - Engine Off
▼ The ignition is switched ON.
▼ The engine stop switch is in the RUN
position.
Motorcycle Stationary - Engine Running
▼ Neutral gear is selected or the clutch
is pulled in.
Motorcycle in Motion
Within 30 seconds of selecting a riding
mode the rider must carry out the
following simultaneously:
▼ Close the throttle.
▼ Make sure that the brakes are not
engaged (allow the motorcycle to
coast).
Note
It is not possible to select RIDER modes
whilst the motorcycle is in motion, if the
TC settings are set to OFF.
In this case, the motorcycle must be
brought to a stop before the riding mode
change can take place.
If
a
riding
mode
completed, the riding mode icon will
alternate between the previous riding
mode and the newly selected riding
mode until the change is complete or it
is cancelled.
The riding mode selection is now
complete and normal riding can be
resumed.
change
is
not
Advertisement
Table of Contents
