Kemppi Mastertig MLS 3003 ACDC Service Manual page 5

Setup functions
Start current level
Current "freezing"
TIG -torch auxiliary switches (RTC
20) *
TIG -torch auxiliary switches (RTC
20) activation *
Cooling unit flow control *
Cooling unit control *
Coolant temperature watch *
Remote controller automatic
detection *
End current level
Tungsten electrode type ***
* Setting is always on ** Adjustable also by the Quick Setup ***Depends on panel software version
ON Start current level in use
A13
OFF Start current level not in use
ON During downslope the current can be "frozen"
onto a certain level, using the start switch
A14
OFF "Freeze" function is OFF
ON Torch auxiliary switches are used to select
memory channels
A15
OFF Torch auxiliary switches adjust welding current
ON Auxiliary switches are always active
A16
OFF Auxiliary switches are active only when torch
control is selected
ON Flow control is active
A17
OFF Flow control is not active
ON Controlled run
A19
OFF Continous run
ON Temperature watch is active
A20
OFF Temperature watch is not active
ON Automatic detection is ON
A21
OFF Automatic detection is OFF
ON 4T-LOG: End current level is in use
A22
OFF MINILOG: End current level is not in use
NOR Normal = Gray tungsten
A23
GRN GRN = Green tungsten
5