Understanding The System Status Leds; How To Connect To The Console Port; Figure 19: System Status Leds; Table 9: System Status Leds - Edge-Core ECS4510-12PD Installation Manual

Chapter 6
| Switch Management

Understanding the System Status LEDs

Understanding the System Status LEDs

How to Connect to the Console Port

The switch includes a display panel of key system LED indicators. The LEDs, which
are located on the front panel, are shown below and described in the following
table.

Figure 19: System Status LEDs

1
System Status LEDs
(

Table 9: System Status LEDs

LED Condition
Pwr On Green
Off
Diag On Green
(Diagnostic)
On Amber
Flashing Amber
The RJ-45 Console port on the rear panel of the switch is used to connect a console
device to the switch for out-of-band console configuration. The console device can
be a PC or workstation running a VT-100 terminal emulator, or a VT-100 terminal. A
console cable is supplied with the switch for connecting to a PC's RS-232 serial DB-9
DTE (COM) port.
Note: To connect to notebooks or other PCs that do not have a DB-9 COM port, use
a USB-to-male DB-9 adapter cable (not included with the switch).
1
Status
Internal power operating normally.
No power is connected or the internal power supply has
failed.
The system diagnostic test has completed successfully.
The system is booting up and executing a self-diagnostic
test.
The system self-diagnostic test has detected a fault.
– 44 –