Figure 13: Connecting Dc Power - Edge-Core ECS4510-12PD Installation Manual

Figure 13: Connecting DC Power

1
1
DC Power Input Socket
2.
Insert the plug directly into the 3-pin DC input socket on the back of the switch.
Caution: When connecting to a DC power source, do not use a wiring gauge less
than 22 AWG.
3.
Check the LED indicators on the switch front panel as the unit is powered on to
verify that power is being received. If not, recheck the power cord connections
at the AC supply source and back panel power input connector.
Connecting the Switch to an External DC Power Source
2
– 29 –
Chapter 4
| Power and Grounding
2
Use 20 to 22 AWG DC wiring to connect
an external DC power source to the DC
terminal block/power plug supplied
with the switch.