Figure 4: Connecting Dc Power - Edge-Core ECS4510-12PD Installation Manual

Chapter 2
| Installation Overview
Switch Installation Tasks
Task 3
Task 4
Connect DC Power to Power On
Connect the supplied DC power plug to a DC power source and then insert the
plug into the three-pin DC power socket on the rear of the switch.
-or-
Using an Ethernet cable, connect any one of ports 1 to 8 to a PoE PD capable
device.
Go to the chapter

Figure 4: Connecting DC Power

1
1
DC Power Input Socket
Verify Switch Operation
Verify basic switch operation by checking the system LEDs.
When operating normally, the Pwr and Diag LED should both be on green. If either
of these LEDs are on amber, see
Go to the section
"Power and Grounding"
2
"Diagnosing LED Indicators" on page
"Understanding the System Status LEDs" on page 44
– 16 –
2
DC Terminal Block Power Plug
48.