Linking; Dmx Mode; Dmx Addressing - ProLights TRUSSPOD3BAT User Manual

10

3.10 LINKING

1. Connect the DMX OUT of the master unit via 3-pole XLR cable to the DMX IN of the first slave unit.
2. Connect the DMX OUT of the first slave unit to the DMX IN of the second slave unit, etc. until all units
are connected in a chain.

3.11 DMX MODE

• Press the button MENU so many times until shows, [CH3] or [CH8] and press the button ENTER to confirm.
• Press the button UP/DOWN to select the desired DMX address [d001 - d512]. Press and hold to scroll
quickly. Press ENTER button to store.
The tables on page 12 indicate the operating mode and DMX value. The TRUSSPOD3BAT is equipped with
3 pole XLR connections.

3.12 DMX ADDRESSING

To able to operate the TRUSSPOD3BAT with a light controller, adjust the DMX start address for the first a
DMX channel. If e. g. address 33 on the controller is provided for controlling the function of the first DMX
channel, adjust the start address 33 on the TRUSSPOD3BAT. The other functions of the light effect panel
are then automatically assigned to the following addresses.
An example with the start address 33 is shown below:
Number of Start address
DMX channels (example)
3 33
8 33
DMX Address: 33
DMX512 Controller
TRUSSpOD3BAT
DMX Address
occupied address for unit No. 1
33-35
33-40
DMX Address: 41
Example 8 DMX channels configuration
Next possible start
address for unit No. 2
36
41
DMX Address: 49
Next possible start
address for unit No. 3
39
49
DMX Address: 57
Fig.4
Next possible start
42
57
. . . . . . . . . . . .