Command Tp - Trigger Polarity; Command Tr - Trigger Mode; Command Ts - Test Pattern - JAI CV-L107CL User Manual

8.32 Command TP – Trigger polarity
Settings:
8.33 Command TR – Trigger Mode
Selects the trigger mode of the camera. Depending on the mode used, it allows the scan
rate to either be programmed by an internal timing generator or by and external trigger
pulse. See chapter 6 for details on the operation modes.
Settings:
Associated functions:
8.34 Command TS – Test pattern
This allows the camera to output a number of test patterns for set-up and troubleshooting.
Settings:
Signal
32 (8)
10bit (8-bit)
890 (222)
10bit (8-bit)
Signal (RGB)
32 (8)
10bit (8-bit)
CV-L107CL
0=Active Low (factory default)
1=Active High
0=No-Shutter mode
1=Shutter-Select mode
2=Pulse Width Control (PWC) mode
Command TG (trigger origin)
Command TI (trigger input)
Command TP (trigger polarity)
0=off
1=Color bar
2=Gray wedge
3=Gray bars
4=White (890LSB)
W Y
256 256 256
128
0
1
Fig. 16 Color bar test pattern
0
1
Fig. 17 Grey wedge test pattern
Cy G Mg R
256 256 256
Pixel count
Pixel count
33
B
256
128
2048
2048