Command Ah - Activate One-Push Auto White Balance (Awb) - Shutter; Command Ba - Bit Allocation; Command Bi - Binning (Horizontal Only) - JAI CV-L107CL User Manual

Important Note:
 When color temperature of used illumination exceeds the range of adjustment, proper
white balance may not be obtained.
 The data can be stored in camera memory for use at next start up.
 This function can work on External trigger mode.
 Please refer Chapter 7.5 operation mode for the details.
 The S/N ratio of the output will change as a result of this function.
8.6

Command AH - Activate One-push Auto White Balance (AWB) - Shutter

By sending this command via the serial communication, the shutter based One-Push AWB
function is activated. The white balance function takes approximately 3 seconds to
complete. During this time the rear panel LED will show orange.
This function operates in two steps. First the Red-to-Green channel difference and the
Blue-to-Green channel difference is calculated separately. Then the exposure time of the
Blue and Red Channel is automatically adjusted, to obtain the same output level on all
three channels.
Settings:
Applicable modes:
Associated functions:
Important Note:
 When color temperature of used illumination exceeds the range of adjustment, proper
white balance may not be obtained.
 The data can be stored in camera memory for use at next start up.
 This function can work on External trigger mode.
 Please refer Chapter 7.5 operation mode for the details.
 The S/N ratio of the output will remain constant for all channels
8.7 Command BA – Bit Allocation
This function lets the user select whether the video data is presented as 3 x 8 (24)-bit or 3
x 10 (30)-bit on the Camera Link output. The internal processing in the camera is based on
a 12 bit A/D signal. The 24-bit and 30-bit function removes the least significant bits from
the 12 bit signal.
Settings:
Applicable modes:
8.8 Command BI – Binning (Horizontal only)
This function reduces the number of pixels to 1024 without affecting the line rate. Two
adjacent pixels are combined at the output stage and read out as one pixel. Sensitivity is
doubled as a result of binning.
Settings:
Applicable modes:
Important Note:
 Setting data is stored in camera memory for use at next start up
 This function is available for all modes.
CV-L107CL
0 = activate automatic process
Shutter-Select mode only
Command WB
0=24-bit, 1=30-bit
All
1=binning on, 0=binning off
All
26