Table of Contents
Advertisement
Chapter 2 Getting Started — Attaching/removing the projection lens
Attaching/removing the projection lens
Move the lens position to the home position before replacing or removing the projection lens. (x page 71)
Attention
f Do not attach or remove the projection lens while the projector is installed to a ceiling or in a high location.
f Replace the projection lens after turning off the projector.
f Do not touch the electric contacts of the projection lens. Dust or dirt may cause poor contact.
f Do not touch the surface of the projection lens with your bare hands.
f Do not turn the gear of the projection lens by hand. Doing so may damage the motor.
f Before attaching the projection lens, remove the lens cover attached to the projection lens.
f Panasonic Connect Co., Ltd. takes no responsibility for any damage or malfunction of the product resulting from the use of projection lenses
which are not manufactured by Panasonic Connect Co., Ltd. Be sure to use the specified projection lenses.
Note
f For the adjustment procedure of the focus, zoom, and lens shift after attaching the projector lens, refer to "Adjusting the focus, zoom, and
lens shift" (x page 68).
f For the adjustment procedure of the focus balance in the center and periphery of the projected image when the Zoom Lens (Model No.:
ET-EMW200, ET-EMW300, ET-EMW400, ET-EMW500, ET-EMU100) is used, refer to "Adjusting the focus balance" (x page 69).
Attaching the projection lens
Attach the projection lens using the following procedure.
Start from Step 2) when the dustproof sponge is already removed.
f Tool used: Ball point hex driver (diagonal 2.5 mm (3/32"))
Dustproof sponge
Fig. 1
Mark on the projection lens (red)
Protruding mark on the projector
Fig. 4
Lens fixing screws
Fig. 7
Top slide cover
Fig. 2
Lens lock lever
Fig. 5
Lens fixing screws
Top slide cover attachment line
Lens lock lever
Lens fixing screw
Fig. 3
Screw hole
Fig. 6
ENGLISH - 45
Advertisement
Table of Contents
