38 m (125')
Motor
3.2.2.5 Recommended Serial Communication Cable Lengths
Connector J8 on the Regulator boards is an RS 232 serial communication port. This connector
allows the GV3000 drive to communicate with external devices such as a personal computer using
RS 232 protocol. See table A.5. Two RS 232 cables are available from Reliance: a 3.5 meter (12 feet)
D shell 9 pin to 9 pin cable (M/N 615184 1A) and a 0.3 meter (1 foot) D shell 9 pin to 25 pin adaptor
cable (M/N 615184 2A). User constructed cables can be up to 15 meters (50 feet) in length. Note that
for communication between a GV3000 drive and a personal computer, the Control and Configuration
software must also be used. Refer to instruction manual D2 3348 for more information.
The Regulator boards have one set of RS 232 transmit/receive lines. These lines can be accessed by
only one device at a time: connector J8, the RS 232 terminals (1 3) on the terminal strip, or an
Operator Interface module (OIM).
3.2.3 Selecting Input Line Branch Circuit Fuses
CAUTION: The NEC/CEC requires that upstream branch circuit protection be provided to protect input pow
er wiring. Install the fuses recommended in table 3.9. Do not exceed the fuse ratings. Failure to observe this
precaution could result in damage to or destruction of the equipment.
Input line branch circuit protection fuses must be used to protect the input power lines. See figures
5.1 and 5.2. Recommended fuse values are shown in table 3.9. The input fuse ratings listed in table
3.9 are applicable for one drive per branch circuit. No other load may be applied to that fused circuit.
Downloaded from StockCheck.com
GV3000
Drive
38 m (125')
Motor
Figure 3.3 Single and Multiple Motor Lead Lengths
GV3000
Drive
15 m (50')
60 m (200')
Motor
Motor
GV3000
Drive
76 m (250')
Motor
GV3000
Drive
60 m (200')
8 m (25')
8 m (25')
Motor
Motor
3 7