Entering Parameters - Thermo Scientific SL40 Instruction Manual

4
Operation

Entering Parameters

Entering Parameters
The Thermo Scientific SL40 offers you a total of 9 acceleration and 10 braking curves with which
samples and gradients can be centrifuged.
After the centrifuge is turned on, the last running profile selected is shown.
Acceleration Curve
1. Press the
menu.
The display shows the message "Acceleration"
2. Select the profile by pressing the
Braking Profile
1. Press the
The display shows the message "Set Deceleration"
2. Select the profile by pressing the
Preselecting Speed / RCF
1. Press the
The display shows the "RPM" or the "RCF"-value depending on the display setting. Press the
2. Enter the desired value by pressing the
Note If an extremely low RCF value has been selected, it will be corrected automatically if the
resulting speed is less than 300 rpm.
4-4 SL40 / 40R
key below the ACC display in order to open the acceleration profile selection
key below the DEC display in order to open the braking profile selection menu.
key below the "SPEED" display.
key to toggle between the two values.
key, until the desired acceleration curve shows.
key, until the desired deceleration curve shows.
key repeatedly, until the desired value shows.
Thermo Scientific