Table of Contents
Advertisement
SEBU9068-03
4. Install the engine oil filter, spin on the oil filter until
the O ring seal contacts the oil filter base. Then,
rotate the oil filter ¾ of a full turn, by hand only.
Vertically Up Oil Filter
Illustration 60
(4) Vertically up oil filter
Some oil filters may be installed vertically up. Use the
same procedure in order to replace the oil filter.
Ensure that all the oil has drained from the filter
before removal.
Fill the Oil Pan
1. Remove the oil filler cap. Refer to this Operation
and Maintenance Manual, "Fluid
Recommendations" for more information on
suitable oils. Fill the oil pan with the correct
amount of new engine lubricating oil. Refer to this
Operation and Maintenance Manual, "Refill
Capacities" for more information on refill
capacities.
NOTICE
If equipped with an auxiliary oil filter system or a re-
mote filter system, follow the OEM or the filter manu-
factures recommendations. Under filling or over filling
the crankcase with oil can cause engine damage.
2. Start the engine and run the engine at "LOW IDLE"
for 2 minutes. Perform this procedure in order to
ensure that the lubrication system has oil and that
the oil filters are filled. Inspect the oil filter for oil
leaks.
3. Stop the engine and allow the oil to drain back to
the oil pan for a minimum of 10 minutes.
Illustration 61
Typical example
4. Remove the engine oil level gauge in order to
check the oil level. Maintain the oil level between
the MIN mark and MAX mark on the engine oil
level gauge. Do not fill the crankcase above the
MAX mark.
g02596778
Fan Clearance - Check
There are different types of cooling systems. Refer to
the OEM for information on clearance for the fan.
Ensure that the engine is stopped. Ensure that the
battery disconnect switch is in the OFF position.
Ensure that the cooling system is full. The clearance
between the cover (1) and the fan (2) will require
checking. The gap (A) between the edge of the cover
and the tip of the fan blade must be checked in four
equally spaced positions.
103
Maintenance Section
Fan Clearance - Check
g02829378
i04401341
Advertisement
Table of Contents
