Table of Contents
Advertisement
100
Maintenance Section
Engine Mounts - Inspect
2. If necessary, remove breather pipes on cover (6).
Remove nuts (7) and remove cover (6) from
housing (1).
3. Remove circlip (4) and remove the breather
element (3) and discard.
4. Remove the O ring seal (5) from the cover.
Install the Breather Element
Ensure that all the components are clean and free
from damage.
Illustration 56
Typical example
(A) Diameter
(B) Diameter
1. Install a new O ring seal (5) onto the cover (6).
Note: The breather element must have the correct
orientation before installation. Diameter (A) is visibly
larger than diameter (B).
2. Install diameter (A) of the breather element (3)
onto the shaft (2). When correctly installed the part
number of the breather element will be visible.
3. Install circlip (4) and cover (6). Install nuts (7) and
tighten to 25 N·m (18 lb ft). If necessary, install
breather pipes to cover.
4. Install the guard, refer to OEM.
Engine Mounts - Inspect
Note: The engine mounts may not have been
supplied by Perkins. Refer to the Original Equipment
Manufacturer (OEM) information for further details on
the engine mounts and the correct bolt torque.
Inspect the engine mounts for deterioration and for
correct bolt torque. Excessive engine vibration can
be caused by the following conditions:
• Incorrect mounting of the engine
• Deterioration of the engine mounts
• Loose engine mounts
Any engine mount that shows deterioration should be
replaced. Refer to the OEM information for the
recommended torques.
When the engine mounts are supplied by Perkins the
maintenance procedure will be supplied in the
Disassembly and Assembly manual for your engine.
Engine Oil Level - Check
g02827300
Hot oil and hot components can cause personal
injury. Do not allow hot oil or hot components to
contact the skin.
Illustration 57
Typical example
SEBU9068-03
i07819538
i04728471
g02829378
Advertisement
Table of Contents
