Table of Contents
Advertisement
Operation
Starting Operation
Observe correct mains voltage! The voltage of the power source must agree with the voltage specified
on the type plate of the power tool.
Switch ON: Push to the top as arrow 1 direction; Push back to max. as
arrow 2 direction(power source on), then push as arrow
1 direction to max.( lock switch).
Switch OFF: When press the switch button again, switch is to off positon.
For low temperatures, the power tool reaches the full impact rate only after
a certain time.
This start-up time can be shortened by striking the chisel in the power tool
against the floor one time.
Shock absorption Equipment 4
The XP-G55VB is equipped with an active vibration reduction system, which cuts vibration of that of the
without Active Vibration Reduction. This may significantly reduce the exposure level over the total
working period. protect the operator form the effects of vibration.
Setting the Impact Rate
The electronic control enables stepless speed preselection in accordance with the material to be worked.
The constant electronic control keeps the preselected impact rate nearly constant between no-load and
load conditions.
Select the impact rate with the Speed Adjuster Function Knob 6 according to the material.
The data in the following table are recommended values.
Speed Adjuster Function Knob 6
1
2
3
4
5
6
Changing the Chiselling Position (Vario-lock)
The chisel can be locked in 12 positions. In this manner, the optimum working position can be set for each
application.
Insert the chisel into the tool holder.
Push the Move limited ring 3 forward and turn the chisel to the required position with the Move limited
ring 3.
Release the Move limited ring 3 and turn the chisel until it latches.
Impact frequency(
min
1000
1200
1350
1550
1750
1900
-1
)
Advertisement
Table of Contents
