Table of Contents
Advertisement
GENERAL INFORMATION
WARNING!
Lethal Voltage
WARNING!
Fire Hazard
CAUTION!
Equipment Damage
CAUTION!
Equipment Damage
Review the system configuration to identify all possible sources
of energy. Ensure ALL sources of power are disconnected before
performing any installation or maintenance on this equipment.
Confirm that the terminals are de-energized using a validated
voltmeter (rated for a minimum 1000 VAC and 1000 VDC) to verify
the de-energized condition.
Do not perform any servicing other than that specified in the installation
instructions unless qualified to do so, or have been instructed to do so
by Go Power! Technical Support personnel.
To avoid electric shock, disconnect the DC input and AC input of
the inverter at least 5 minutes before performing any installation
or maintenance.
Do not tighten the AC and DC terminals or pull on the AC and DC wiring
when the inverter is running.
Do not keep combustible or flammable materials in the same room with
the equipment. Some products contain relays with moving parts and
are not ignition-protected.
Ensure AC, DC, and ground cable sizes conform to local codes. See
product manuals for minimum size requirements.
Ensure all conductors are in good condition.
Do not operate the unit with damaged or substandard cabling.
When connecting cables from the inverter to the battery terminals,
ensure the proper polarity is observed. Connecting the cables
incorrectly can damage or destroy the equipment and void the
product warranty.
Thoroughly inspect the equipment prior to energizing. Verify that no
tools or equipment have been inadvertently left behind.
Keep all vents clear of obstructions that can prevent proper air flow
around, or through, the unit.
Static electricity may damage electronic components. Take appropriate
steps to prevent such damage to the inverter; otherwise the warranty
may be annulled.
gpelectric.com | [page 7]
Advertisement
Table of Contents
