Removing And Installing The Battery Pack - Fujitsu Stylistic LT LT User Manual

appears in the Status display. If the battery pack charge is 90% or higher when you
connect DC power, the battery pack will not charge; this prevents overcharging the
battery pack.
2. Look at the Power icon in the Status display to determine the approximate percent of
charge in the battery pack. See "Status Indicators" in Chapter 1 of this manual for
a description of the Power icon.
As long as DC power remains connected to the pen tablet, the charging process continues
until the battery pack charge reaches 100%. Charge times shown in Table 2-3 are for a
fully discharged battery pack charging while the pen tablet is and is not in use.
Approximate Charge Time
3-Cell
2 hours
Also note the following with respect to charging the battery pack:
• You can use the system, suspend system operation, or shut down and turn off the
system without interrupting the charging process; however, using the system while
the battery pack is charging will cause the battery pack to charge at a slower rate, as
noted in Table 2-3.
• As noted in the procedure above, the system will not begin charging the battery
pack if the battery pack charge level is 90% or higher when the system is initially
connected to external DC power. (This prevents the battery pack from being
overcharged.)
• The Stylistic LT battery pack uses lithium ion battery cells which have no
"memory effect." You do not need to discharge the battery pack before you begin
charging.

Removing and Installing the Battery Pack

The battery pack can be removed from the pen tablet and swapped with a charged
battery pack. The battery pack can then be charged in an external charger if one is
available. To remove the battery pack from the pen tablet:
Table 2-3 Battery Pack Charging Time
(tablet not in use)
6-Cell
3 hours
Approximate Charge Time
(tablet in use)
3-Cell
4 to 6 hours
Removing and Installing the Battery Pack
6-Cell
8 to 12 hours
2
2-13