Resuming System Operation - Fujitsu Stylistic LT LT User Manual

system operation. (If the battery charge drops to the Critically Low level while the
system is in Suspend-to-RAM mode, the system stays in Suspend-to-RAM mode.)
• Suspending system operation interrupts data communications; however, some
programs may block the system from suspending to prevent an interruption.
• The Suspend/Resume button on your system may be configured during system
setup to act as an On-only button. If this is the case, pressing the Suspend/
Resume button will not suspend system operation as described here. Contact
your IS department or reseller if your system configuration is not suitable.
• If your system is equipped with a PC Card that allows you to connect to a wired or
wireless network, you may be logged off the network after a period of inactivity
while system operation is suspended. Contact your network administrator or local
help desk for details on log-off parameters for your network.

Resuming System Operation

To resume system operation, (from either Suspend-to-RAM or Save-to-Disk modes),
press the Suspend/Resume button.
• From Suspend-to-RAM mode
After a few seconds, the system returns to the Fully On state and system operation
resumes. Note that the display turns on shortly before the pen becomes active due to
the power-up sequences observed by the system.
• From Save-to-Disk mode
Active data is read from the hard disk drive, and after 15 to 30 seconds, the system
returns to the Fully On state.
Note that power to several system components must be restored before system
operation resumes. Allow sufficient time for system operation to resume before
attempting to use the system. If your system uses Save-to-Disk mode, it will take
longer to resume operation as compared to using Suspend-to-RAM mode. Time is
needed to read data from the hard disk drive.
Use the system as you normally would once system operation resumes.
All programs resume at the point where execution stopped when system operation was
suspended.
Resuming System Operation
2
2-9