Fujitsu Stylistic LT LT User Manual page 24

When prompted by your Stylistic LT pen tablet to enter a password, perform the
following procedure:
1. Ensure that the system speaker is on. Audible signals are used later in this
procedure.
2. Place the security card on the display screen in a position similar to Figure 2-2a.
Note that the card can be placed anywhere along the edge, as long as it is
positioned with the cut corner facing the upper left.
3. Hold the card firmly against an edge of the screen frame. With your pen, tap the
Card Locator/Escape hole just under the cut corner, as in Figure 2-2b.
• If you hear two beeps in succession, proceed to step 4.
• If you hear four beeps in succession, return to step 2.
4. With your pen, tap the Card Locator/Enter hole, as in Figure 2-2c.
• If you hear two beeps in succession, proceed to step 5.
• If you hear four beeps in succession, return to step 2.
Note: Your password is created during system configuration. To determine your
password, check with your system administrator or supervisor.
5. Tap in your password using the password input holes, as in Figure 2-2d. Up to
seven characters can be used for a password (including letters and symbols). If
you make a mistake while entering your password, tap the Card Locator/Escape
hole, and repeat steps 2 through 4.
6. After entering your password, tap the Card Locator/Enter hole.
7. If you enter the wrong password, you receive a Setup Warning message. If this
occurs, tap Continue and return to step 2.
Notes: • If you have difficulty entering a password, or you move the security card while
entering the password, tap the [Esc] key on the keypad until the hovering/
security LED stops blinking. At that point, begin the input procedure again.
• If you enter the incorrect password three times in a row, you receive a System
Disabled message, and access to the computer is disabled. If this happens, press the
reset switch to restart the computer.
2-6 Using the Stylistic LT Pen Tablet