Fujitsu Stylistic LT LT User Manual page 20

• Off state
All system functions are turned off to conserve power. The system does not respond
to the pen or other input. The system boots at the next system power-on.
Your system may be configured to enter some of these states automatically after a
period of inactivity to conserve battery power.
When you use the Stylistic LT pen tablet, you can change the current system state in a
number of ways, depending on which state the system is in. To determine the current
system state, observe the Power icon in the Status display. Table 2-1 gives the
different system states represented by the Power icon and describes how you can
change the system state from the current state.
Power Icon
Appearance
Power icon
displayed
continuously
Power icon
blinking
Power icon not
displayed
* Information in Table 2-1 is supplied to help you understand which system states your system
can enter from the current system state. Refer to the procedures on starting the system,
shutting down the system, suspending system operation, and resuming system operation
given later in this chapter for details on changing the current system state.
†
Your system may be configured to use either Suspend-to-RAM mode, Save-to-Disk mode, or
may use both modes sequentially.
2-2 Using the Stylistic LT Pen Tablet
Table 2-1 Changing System States
Current State
Fully On,
Idle,
or
Standby
†
Suspend-to-RAM
Off or
†
Save-to-Disk
To Change State
To turn the system off, shut down the system using
a software shut down.
To enter the Suspend-to-RAM or Save-to-Disk
suspend system operation using either a hardware or
software suspend, or tap the Save-to-Disk hotpad.
To turn the system on, resume system operation by
pressing the Suspend/Resume button.
To turn the system off, resume system operation,
then shut down your system.
To turn the system on, start your system, or resume
system operation.
*
†
state,