Shutting Down The System; Suspending System Operation - Fujitsu Stylistic LT LT User Manual

Shutting Down the System

Follow these steps to shut down and turn off your system:
1. If system operation has been suspended, resume system operation. See "Resuming
System Operation" later in this chapter for details.
2. Save your work and close all running programs.
3. Choose Shut Down from the Windows 98 Start menu and carry out the Shut Down
command.
The system is now in the Off state.

Suspending System Operation

The Stylistic LT pen tablet allows you to suspend the system operation without closing
programs or exiting the operating system. Use this feature to conserve battery power
when a system shutdown is inconvenient. There are two different suspend modes:
Suspend-to-RAM and Save-to-Disk. In Suspend-to-RAM mode, active data is saved
by maintaining power to RAM while most other system components are powered
off. In Save-to-Disk mode, active data is stored on the hard disk drive and power
usage is reduced to the same level used in the Off state.
To suspend system operation, perform one of the following procedures:
• Press the Suspend/Resume button, or carry out the Suspend command from your
operating system or power management program. (If your system is configured to
suspend operation using Save-to-Disk mode, which is explained later in this
procedure, a message is displayed while data is saved to your hard disk.)
• Tap the Save-to-Disk hotpad key.
If you are replacing the battery pack, be sure to Save-to-Disk before you
remove the battery pack. Failure to do so may result in loss of your unsaved
data.
The Power icon blinks when system operation is suspended-to-RAM, and is off
when saved-to-disk. The state your system enters is dependent upon how your
system is configured. At this point, programs that were running are stopped,
active data is saved, and the system enters one of two different low-power states,
or suspend modes, as explained in the following paragraphs.
Caution
Shutting Down the System
2
2
2-7