Removing And Installing A Battery Pack - Fujitsu PenCentra 130 User Manual
Hide thumbs
Also See for PenCentra 130:
- Datasheet (3 pages) ,
- User instructions (2 pages) ,
- User manual (8 pages)
Table of Contents
Advertisement
Removing and Installing a Battery Pack
To remove the PenCentra 130 battery pack, perform the following steps:
1. Save any active data and suspend your system.
2. Hold the system face down, with the arrow on the battery compartment pointing
towards you (see Figure 2-3).
PS/2-style
Port
3. Using the system pen, push the spring-loaded battery latch to the left.
4. While the battery latch is pushed to the left, slide the battery pack out of the
battery tray by pulling it towards you. When the battery is clear of the latch
mechanism, release the battery latch.
5. Resume system operation.
To install a new or recharged battery pack, slide it into the battery tray and firmly
push it in until the latch clicks into place.
2-6
Using the PenCentra 130
Figure 2-3
Removing/Installing the Battery Pack
2
Battery Pack
Latch
Battery Pack
Advertisement
Table of Contents
