Table of Contents
Advertisement
5.2.2
Baking chamber light switch
By setting switch on "on", the switch and the chamber light turn on.
5.2.3 Temperature regulators
Each baking chamber has two independent temperature regulators, one
connected to the oven roof heating elements, and the other one to the
bedplate heating elements. These regulators ensure an even distribution of
the heat inside the baking chamber so as to obtain an even cooking.
Each temperature regulator by probe controls the temperature of its own
heating element.
If the temperature regulator is set on 200°C, the heating element will
operate until the temperature of 200°C is reach. Once reached this
condition the heating element switch off and it will switch on only when the
probe will measure a 2 degree inferior temperature from the starting
temperature.
5.2.4 Switch for suction hood
The switch
control
is placed on the side part of the
control
panel, on the upper side (Pos.1 of
Fig. 5.2).
Push this switch on position "on",
the suction motors is started.
Push this switch on position "off"
to stop it.
for
suction hood
CITIZEN EP70
5. WORKING
Fig.5.2
17
Advertisement
Table of Contents
